Arrington Accuracy Works Store

Surprise, AZ

(Please call or Email for appointments & shipping instructions)

Phone 623-582-5066 - Fax 623-582-5066

Email ArAccuracy@aol.com

Home
Arrington Magazine Articles
Leatherwood Scopes & Mounts  
Arms Rings & Mounts  
Tools
Apparel
Parts - AR
Parts - M14
Parts - Garand
1903/1903A3 Springfield Parts 
M1 Garand Rifles & other Firearms 
 Gift Certificates

 Special Mounting Systems

Search

 



$429.00
3DSMT
Finally a mount that gives over 100 minutes of external vertical precise adjustment and leaves all the internal adjustment for zeroing and minor impact changes. This mount also has a gross windage adjustment that lets the shooter center his internal windage adjustment. This massive all-steel mount is very precise. It is the answer to extreme long range shooting. The 3D mount accepts both 30mm and 1 inch diameter scopes.
Quantity   




$79.00
M98MT
The 98k Rear Sight Scope mount is designed to allow hunters and collectors alike to shoot their M98k’s without alteration to the rifle. It is totally machined from steel, attaches in about 5 minutes and has gross windage and elevation adjustment. Once tightened in place it is very rigid and provides a truly dependable scope mount.
Quantity   




$89.00
LSM
The Lever-Lock mount makes mounting and dismounting your rifle optics easy, without tools and with no loss of zero. Ideal for mounting on rifles like “flat top” AR’s. with your scope mounted in the Lever-Lock mount, just turn the leer to open the base clamps, and slide the lever-Lock mount onto the rifle’s rail. Lock the lever back and your scope is clamped on with rock solid force for a no-movement installation. For removal, just turn the lever to open the clamps and slide your scope and mount off its rail. It’s just that easy. It fits any one or two piece Weaver-style or Picatinny rail. It has a side-mounted tension adjustment which also accommodates variations in rail widths. There are twelve top rail mounting slots to allow you to adjust your optics placement just right. The wear surfaces are heat-treated steel. The mount has built in Windage adjustment.
Quantity   




$139.00
M14MT
This mount is based on 37 years of experience of mounting scopes on the M-14 rifle. The inconsistent dimensions on both original M-14’s and later M1A’s make dependable scope mounting a challenge. This new mount is designed to compensate for these problems. All the recoil loading is taken by the clip guide slot so the forces are parallel to the gun axis. The mount has built in windage adjustment. It is sufficiently low to allow the use of a battle sight zero on the iron sights. It is totally CNC machined from steel and properly heat treated. The scope base is machined to Leatherwood dimensions that fit both Weaver type and Picatinny rings.
Quantity   


 

VisaMC

Created by Computer Help